The PGXD14/85 is a digital wireless system with the WL185 lavalier microphone. PGX Digital adds the clarity of 24-bit digital audio to the famed PGX line of Shure wireless products. Offering tailored wireless solutions for vocalists, guitarists, and presenters, PGX Digital combines the trusted legacy of Shure microphones with state of the art, 24-bit digital wireless technology that delivers strong, clean RF performance. The result is wireless audio that sounds like wired, rock-solid RF signal, and simple setup and operation.

The PGX Digital Vocal Wireless System from Shure adds the clarity of 24-bit digital audio to the legacy of trusted Shure microphone options for wireless performance. This system includes the WL85 cardioid condenser lavalier for general-purpose sound reinforcement applications requiring good rejection of ambient noise. Also includes tie clip and windscreen. Included: PGXD4 wireless receiver, PGXD1 bodypack transmitter, WL85 lavalier microphone, tie clip, windscreen, padded carrying case.

PGXD1 Bodypack Transmitter with WL185 Lavalier Microphone Features

• Cardioid condenser lavalier microphone for general purpose soundreinforcement
• Smooth extended frequency response with presence rise specially tailoredfor chestworn microphone operation
• Power, mute, and battery status LED
• Up to 10 hours of continuous use from 2 AA batteries
• 200 ft (60 m) operating range
• Rugged construction for reliable performance show after show
• Low profile bodypack, easily clips onto belts or clothing

PGXD4 Wireless Receiver Features

• 24-bit / 48 kHz digital technology for incredibly accurate sound
• Automatic frequency selection locates a clear channel instantly
• One-touch sync automatically syncs the transmitter and receiver
• True digital diversity for rock-solid wireless signal reliability
• Up to 10 compatible channels per frequency band
• ¼” and XLR audio outputs
• Included padded carrying case for portability and protection

PGXD1 Specifications

• Audio Input Level: +10 dBV maximum, at minimum gain setting, -16 dBVmaximum, at maximum gain setting
• Gain Adjustment Range: 26 dB
• Input Impedance: 1 M ohms
• RF Output Level: 10 mW maximum (dependent on applicablecountryregulations)
• Dimensions: 108 mm H x 64 mm W x 19 mm D (4.25 x 2.50 x 0.75 in.)
• Weight: 128 grams (4.5 oz.) without batteries
• Housing: Molded polycarbonate case
• Power Requirements: 2 “AA” size
• Battery Life: Up to 10 hours

PGXD4 Specifications

• Dimensions: 40 mm H X 181 mm W X 104 mm D (1.6 x 7.125 x 4.1 in.)
• Weight: 289 g (10.2 oz.)
• Housing: ABS
• Audio Output Level: (ref. ± 38 kHz deviation, 1 kHz tone): XLR connector(into 3000 O load): -2.5 dBV / 1/4 inch connector (into 10000 O load):+10 dBV
• Impedance: XLR: 50 O / 1/4 inch: 50 O
• Sensitivity: -102 dBm @ 10-5 BER
• Image Rejection: > 70 dB, typical
• XLR output: Impedance balanced; Pin 1: Ground (cable shield), Pin 2:Audio, Pin 3: No Audio
• Audio LED: Red: 2 dB below clip, Amber: 12 dB below clip, Green: 50 dBbelow clip
• Power Requirements:12-18 Vdc at 150 mA, supplied by external power supply
• Pin Assignments:XLR: 1=ground, 2=hot, 3=cold6.35 mm (1/4”) TRS: Tip=audio,Ring=no audio,Sleeve=ground

System Specifications

• Operating Range: 60 m (200 ft.) under typical conditions. Note: actualrange depends on RF signal absorption, reflection and interference.
• RF Carrier Range: X8: 902–928 MHz, X8A: 915–928 MHz, X8B: 902–907.5 MHz,915–928 MHz (Note: varies by region)
  Audio Frequency Response (± 2dB):20-20000 MHz
• System Gain: PGXD2: 0 dB at minimum gain setting, 6.35 mm (1/4“) connector/ -12.5 dB at minimum gain setting, XLR output
  PGXD1: -54.5 dBV/Pa at -10dB gain setting, with SM58 catridge, XLR output
• Total Harmonic Distortion: <0.02%, A-weighted, typical (Ref. 1 kHz, 6dB below input clip)
• Dynamic Range: >108 dB A-weighted
• Operating Temperature Range: -18°C (0°F) to +50°C (+122°F). Note: batterycharacteristics may limit this range.